Knowledgebase: PaperCut
Changing copy timeout (Copicode Terminal)
Posted by , Last modified by Matthew Ryan on 04 January 2013 07:01 PM
The timeout on the Copicode terminals can be adjusted as follows:
  1. Log into the PaperCut web interface
  2. "Devices" tab
  3. Choose the device you wish to change
  4. "Config editor (advanced)" tab
  5. Type "time-out-copier" in the 'quick find' box and press enter
  6. Change this value to the number of seconds you wish the terminal to wait before timing out. Note this timer starts again after each copy.
  7. Press "Update" to save the value.

Repeat these steps for other terminals you wish to change.

There is no need to restart anything after doing the above. The Copicode will pick up this change as part of its check for updates approximately every minute.
(0 vote(s))
Helpful
Not helpful